Below are several downloadable documents about the EDGE-CUTTER
Product Information
EDGE-CUTTER channel flashings are designed to prevent ice build-up, icicles, or ice dams on the roof edge. It can be used with various roofing products such as asphalt shingles, aluminum, steel and even slate. Each 4' aluminum flashing is feathered and has a channel to accommodate the self-regulating heating cable. The flashing is installed under the leading roof edge using screws, nails, or adhesives. The Paladin system or Heat-Line Cut-to-Length self-regulating heating cable is then installed within the channel and a cap secures it in place.
USE ONLY APPROVED SELF-REGULATING HEATING CABLES.
NOT FOR USE WITH CONSTANT WATTAGE HEATING CABLES!
 |
 |
Product Application
The EDGE-CUTTER flashing can be used on low-pitched roofs, fascia, valleys, and drip edges. If a metal roof is present, the EDGE-CUTTER channel flashing should be ordered with a 6 mil urethane membrane factory installed directly onto the flashing to prevent galvanic oxidation between dissimilar metals. Flat and angled EDGE-CUTTER channel flashings are available to suit different application requirements.
In areas where EDGE-CUTTER channel flashings are not desired, the Paladin heating cable can simply be mounted with clips on the roof surface in the conventional serpentine configuration.
Benefits of EDGE-CUTTER
- 4' feathered aluminum flashing complete with cap
- Fast, easy installation
- Can be used under metal, asphalt and slate roof
- For new or existing roofs
- Aesthetically pleasing
- Many different uses
- Can be used with Paladin heating cable sets
- Can be used with Heat-Line cut-to-length heating cables*
- Membrane available
* Approved roof and gutter powered connection kits required.
EDGE-CUTTER often requires consultation as there are large application variables. Heat-Line provides technical support for these situations.
