Product Information
EDGE-CUTTER channel flashings are designed to prevent ice build-up, icicles, or ice dams on the roof edge. It can be used with various roofing products such as asphalt shingles, aluminum, steel and even slate. Each 4' aluminum flashing is feathered and has a channel to accommodate the self-regulating heating cable. The flashing is installed under the leading roof edge using screws, nails, or adhesives. The Paladin system or Heat-Line Cut-to-Length self-regulating heating cable is then installed within the channel and a cap secures it in place.USE ONLY APPROVED SELF-REGULATING HEATING CABLES. NOT FOR USE WITH CONSTANT WATTAGE HEATING CABLES! Product Application 
The EDGE-CUTTER flashing can be used on low-pitched roofs, fascia, valleys, and drip edges. If a metal roof is present, the EDGE-CUTTER channel flashing should be ordered with a 6 mil urethane membrane factory installed directly onto the flashing to prevent galvanic oxidation between dissimilar metals. Flat and angled EDGE-CUTTER channel flashings are available to suit different application requirements.
In areas where EDGE-CUTTER channel flashings are not required, the Paladin heating cable can simply be mounted with clips on the roof surface in the conventional serpentine configuration. Benefits of EDGE-CUTTER
EDGE-CUTTER often requires consultation as there are large application variables. Heat-Line provides technical support for these situations. Below are several downloadable documents about the EDGE-CUTTER: Edge-Cutter Brochure Installation Guide 1 |